52 70143101
Section 6 Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
50. CYLINDER DOOR SWITCH
The door switch should be adjusted so the cylinder
stops when door is opened 2 inches (51 mm), plus
or minus 1/4 inch (6 mm). The switch is normally
open and is closed when the door is closed. If
adjustment is needed, proceed as follows:
a. Close door and start tumble dryer. Slowly open
loading door. Cylinder and heat system should
shut off when door is open 2 inches (51 mm),
plus or minus 1/4 inch (6 mm).
b. Slowly close loading door. When door is 2
inches or less from being fully closed, the
switch actuator on the door should contact the
switch plunger and depress it enough to close
the switch with an audible “click”.
If tab does not depress the switch plunger
enough to operate the switch, bend tab on
loading door OUTWARD and repeat steps “a”
and “b.”.
EU MODELS
European tumble dryers have a second door
switch near the top of the door. Refer to Figure 45.
This switch also should be adjusted so the cylinder
stops when door is opened 2 inches (51 mm), plus
or minus 1/4 inch (6 mm). This switch is normally
closed and is opened by the hinge cam when the
door is opened. If adjustment is needed, proceed
as follows:
a. Remove lower switch actuator so upper switch
click can be heard.
b. Loosen upper door switch screws just enough
so switch can be moved left or right. Move
switch right if door opens too far before switch
clicks. Move switch left if door doesn’t open far
enough before switch clicks.
c. Retighten door switch screws and retest. Repeat
step “b” if further adjustment is needed.
d. Reinstall lower switch actuator.
Figure 45
T275SE1B
"EU" DOOR
SWITCH
DOOR SWITCH
SCREWS
SWITCH
PLUNGER
SWITCH
ACTUATOR
DOOR
To Next Page
Loading...