Installation
F232086
28
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Steam Requirements
(Steam Heat Option Only)
For washer-extractors equipped with optional steam
heat, install piping in accordance with approved
commercial steam practices. Steam requirements are
shown in the table below.
The optional steam connection for above models is
located at the upper right corner of the rear panel, as
seen from the rear.
Table 8
NOTE: Failure to install the supplied steam filter
may void the warranty.
Steam Supply Information
Steam inlet connection, in (mm) 1/2 [DN13] (12.7)
Number of steam inlets 1
Recommended pressure, psi (bar) 30 – 80 (2.0 – 5.4)
Maximum pressure, psi (bar) 80 (5.4)
Never touch internal or external steam
pipes, connections, or components.
These surfaces can be extremely hot and
will cause severe burns. The steam must
be turned off and the pipe, connections,
and components allowed to cool before
the pipe can be touched.
SW014
WARNING
To Next Page
Loading...
