© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Specifications and Dimensions
F8410701 (EN)
28
Electrical Installation Requirements
IMPORTANT: Electrical ratings are subject to
change. Refer to serial decal for electrical ratings
information specific to your machine.
Electrical connections are made at the rear of the
machine. The machine must be connected to the
proper electrical supply shown on the identification
plate attached to the rear of the machine, using copper
conductors only.
IMPORTANT: Alliance Laundry Systems
warranty does not cover components that fail as a
result of improper input voltage.
Make sure the correct transformer jumper (208 Volt or
240 Volt) is in place. Refer to the “optional” Electrical
Service Conversion label located on the back of the
machine near the electrical service input for machine
electrical requirements.
AC inverter drives require a clean power supply free
from voltage spikes and surges. Use voltage monitor
to check incoming power.
The following conditions require corrective action,
contact the local utility to adjust the voltage.
• If the local utility cannot adjust the input voltage,
install a buckboost transformer to lower the input
voltage.
• Input voltage is above 240V or 480V, phase to
ground voltage exceeds 125% of normal line to
line voltage, or 240V open delta configuration
(stinger leg). Contact the distributor or the
manufacturer for assistance.
Electrical shock hazard will result in death
or serious injury. Disconnect electric
power and wait five (5) minutes before
servicing.
W810
WARNING
Dangerous voltages are present inside the
machine. Only qualified personnel should
attempt adjustments and troubleshooting.
Disconnect power from the machine
before removing any cover and guards,
and before attempting any service
procedures.
W736
WARNING
Hazardous Voltage. Can cause shock,
burn or death. Verify that a ground wire
from a proven earth ground is connected
to the lug near the input power block on
this machine.
W360
WARNING
To Next Page
Loading...
