Allied Telesis AlliedWare Plus GS980MX Series - Tools and Material

GS980MX Series Installation Guide for Virtual Chassis Stacking
127
Tools and
Material
The following tools and material are required for installing the switch on
a wall.
Included with switch:
 Wall/equipment rack brackets:
– Two for the GS980MX/28 or GS980MX/28PSm
– Four for the GS980MX/10HSm, GS980MX/18HSm,
GS980MX/52 or GS980MX/52PSm
 Screws for attaching the wall/equipment rack brackets to the
switch:
– Eight for GS980MX/28 or GS980MX/28PSm
– Sixteen for GS980MX/10HSm, GS980MX/18HSm,
GS980MX/52 or GS980MX/52PSm
Length: 6 mm (0.2 in.) Diameter: 4 mm (0.16 in.)
 Anchors for wood or concrete walls:
– Two for the GS980MX/28 or GS980MX/28PSm
– Four for the GS980MX/10HSm, GS980MX/18HSm,
GS980MX/52 or GS980MX/52PSm
Length: 29.6 mm (1.2 in.) Diameter: 6 mm (0.2 in.).
 Screws for wood or concrete walls:
– Two for the GS980MX/28 or GS980MX/28PSm
– Four for the GS980MX/10HSm, GS980MX/18HSm,
GS980MX/52 or GS980MX/52PSm
Length: 32 mm (1.3 in.) Diameter: 4 mm (0.16 in.)
 One power cord retaining clip.
Not included with switch:
 Cross-head screwdriver.
 Stud finder for a wooden wall, capable of identifying the middle of
wall studs and hot electrical wiring.
 Drill and 1/4-inch carbide drill bit (for a concrete wall).
Refer to “Installing the Switch on a Concrete Wall” on page 136.
 Plywood base (if you are installing the switch on a wall with
wooden studs). Refer to “Plywood Base for a Wall with Wooden
Studs” on page 129 for illustrations.
 Four screws for attaching the plywood base to the wall.