Allied Telesis AlliedWare Plus - Figure 48: Tightening the Captive Screw on the Card; Figure 49: Aligning the AT-FAN09 Module in the Slot

Chapter 5: Installing AT-StackQS and AT-x9EM/XT4 Cards
110
10. Tighten the captive screw to secure the card in the switch. Refer to
Figure 48.
Figure 48. Tightening the Captive Screw on the Card
11. Align the AT-FAN09 Module in the slot and carefully slide it into the
switch. Refer to Figure 49.
Figure 49. Aligning the AT-FAN09 Module in the Slot