4
Rear Panel Components
The rear panel of the switch is shown in Figure 2.
Figure 2 Rear Panel
AC Power Receptacle
The switch has a single AC power connector on the back panel, which has
autoswitch AC inputs. The switch can automatically adjust its power setting
to any supply voltage in the range of 90-240VAC.
RS232 Console Port
The RS232 console port is used to start a local management session on the
switch by accessing the AT-S30 management software, which is pre-installed
on the switch, and the management interface. Establishing a local
management session requires a terminal or a personal computer with a
terminal emulator program. The console port uses a standard null-modem
cable. The default settings for the port are as follows:
❑ Baud rate: 9600
❑ Data bits: 8
❑ Parity: none
❑ Stop bits: 1
❑ Flow control: none
RS-232
TERMINAL PORT
RS232 Console Port
AC Connector
To Next Page
Loading...
