Chapter 66: RMON Commands
1002 Section X: Network Management
NO RMON EVENT
Syntax
no rmon event
event_id
Parameters
event_id Specifies the ID number of the event you want to
delete from the switch. You can delete only one event
at a time. The range is 1 to 65535.
Mode
Global Configuration mode
Description
Use this command to delete events from the switch.
Confirmation Command
“SHOW RMON EVENT” on page 1015
Example
This example delete the event with ID 2:
awplus> enable
awplus# configure terminal
awplus(config)# no rmon event 2
To Next Page
Loading...
