Allied Telesis AT-9000/28 - Rmon Event Log

Chapter 66: RMON Commands
1010 Section X: Network Management
RMON EVENT LOG
Syntax
rmon event event_id log description description [owner
owner ]
Parameters
event_id Specifies the ID number of a new event. The range is
1 to 65535.
description Specifies a description of up to 20 alphanumeric
characters for the event. Spaces and special
characters are not allowed.
owner Specifies an owner of up to 20 alphanumeric
characters for the event. Spaces and special
characters are not allowed.
Mode
Global Configuration mode
Description
Use this command to create events for RMON alarms. This type of event
enters a message in the event log when a rising or falling threshold of an
alarm is crossed. The same event can be assigned to multiple alarms.
Confirmation Command
“SHOW RMON EVENT” on page 1015.
Example
awplus> enable
awplus# configure terminal
awplus(config)# rmon event 2 log description port5_traffic
owner John