AT-9000 Switch Command Line User’s Guide
Section X: Network Management 1011
RMON EVENT LOG TRAP
Syntax
rmon event
event_id
log trap
community_string
[description
description
] [owner
owner
]
Parameters
event_id Specifies the ID number of a new event. The range is
1 to 65535.
community_string Specifies the community string assigned the IP
addresses of the network devices that are to receive
the trap. You can specify just one community string.
The community string is case sensitive and must
already exist on the switch.
description Specifies a description of up to 20 alphanumeric
characters for the event. Spaces and special
characters are not allowed.
owner Specifies an owner of up to 20 alphanumeric
characters for the event. Spaces and special
characters are not allowed. You must enter a
description to include an owner.
Mode
Global Configuration mode
Description
Use this command to create events for RMON alarms. This type of event
enters a message in the event log and sends an SNMP trap when a rising
or falling threshold of an alarm is crossed. The same event can be
assigned to multiple alarms.
Confirmation Command
“SHOW RMON EVENT” on page 1015.
Example
awplus> enable
awplus# configure terminal
awplus(config)# rmon event 2 log trap station43a description
broadcast_packets owner jones
To Next Page
Loading...
