Chapter 66: RMON Commands
1012 Section X: Network Management
RMON EVENT TRAP
Syntax
rmon event
event_id
trap
community_string
[description
description
] [owner
owner
]
Parameters
event_id Specifies the ID number of a new event. The range is
1 to 65535.
community_string Specifies the community string assigned the IP
addresses of the network devices that are to receive
the trap. You can specify just one community string.
The community string is case sensitive and must
already exist on the switch.
description Specifies a description of up to 20 alphanumeric
characters for the event. Spaces and special
characters are not allowed.
owner Specifies an owner of up to 20 alphanumeric
characters for the event. Spaces and special
characters are not allowed. You must enter a
description to include an owner.
Mode
Global Configuration mode
Description
Use this command to create events for RMON alarms. This type of event
sends an SNMP trap when a rising or falling threshold of an alarm is
crossed. The same event can be assigned to multiple alarms.
Confirmation Command
“SHOW RMON EVENT” on page 1015.
Example
awplus> enable
awplus# configure terminal
awplus(config)# rmon event 4 trap st_west8 description
router_north
To Next Page
Loading...
