AT-9000 Switch Command Line User’s Guide
Section X: Network Management 1063
NO ACCESS-LIST
Syntax
no access-list
id_number
Parameters
id_number Specifies the ID number of an access list you want to delete
from the switch. You can delete just one access list at a
time with this command.
Mode
Global Configuration mode
Description
Use this command to delete ACLs from the switch. ACLS must first be
removed from their port assignments before they can be deleted. For
instructions, refer to “NO ACCESS-GROUP” on page 1064 and “NO MAC
ACCESS-GROUP” on page 1065.
Confirmation Command
“SHOW ACCESS-LIST” on page 1066
Example
This example deletes the access list with the ID number 3015 from the
switch:
awplus> enable
awplus# con
figure terminal
awplus(config)# no access-list 3015
awplus(config-if)# end
awplus#
show access-list
To Next Page
Loading...
