Chapter 70: Local Manager Accounts
1098 Section XI: Management Security
Deleting Local Manager Accounts
To delete local manager accounts from the switch, use the NO
USERNAME command in the Global Configuration mode. Here is the
format of the command:
no username
name
The NAME parameter specifies the name of the manager account you
want to delete from the switch. The name is case sensitive. You can
delete just one manager account at a time with this command.
Once an account is deleted, it cannot be used to manage the switch. If you
delete the account with which you logged on to the switch, your current
management session is not interrupted. But you will not be able to use that
account again to log in and configure the unit.
This example of the command deletes the manager account bjspring:
awplus> enable
awplus# configure terminal
awplus(config)# no username bjspring
Note
You can delete the default “manager” account from the switch.
Caution
Do not delete all of the manager accounts from the switch. If you do,
you will not be able to manage the switch and will have to contact
Allied Telesis for assistance.
To Next Page
Loading...
