Allied Telesis AT-9000/28 - Enabling the Telnet Server

AT-9000 Switch Command Line User’s Guide
Section XI: Management Security 1113
Enabling the Telnet Server
To enable the server, go to the Global Configuration mode and issue the
SERVICE TELNET command. Here is the command:
awplus> enable
awplus# configure terminal
awplus(config)# service telnet
Once the server is started, you can conduct remote management sessions
over your network from Telnet clients, provided that the switch has a
management IP address. For instructions on how to start a remote Telnet
management session, refer to “Starting a Remote Telnet or SSH
Management Session” on page 60.