Allied Telesis AT-9000/28 - Displaying Port Settings

Chapter 7: Port Parameters
154 Section II: Basic Operations
Displaying Port Settings
To display the speed and duplex mode settings of the ports, use the
SHOW INTERFACE STATUS command in the Privileged Exec mode.
Here is the format:
show interface [ port ] status
This example of the command displays the speed and duplex mode
settings for ports 18 and 20:
awplus# show interface port1.0.18,port1.0.20 status
Here is an example of the information the command displays.
Figure 36. SHOW INTERFACE STATUS Command
The columns are described in Table 9 on page 189.
To display the current status of the ports on the switch, use the SHOW
INTERFACE command in the Privileged Exec mode. Here is the format:
show interface [ port ]
This example displays the settings for ports 1 and 2:
awplus# show interface port1.0.1,port1.0.2
Here is an example of what you will see.
Figure 37. SHOW INTERFACE Command
Port Name Status Vlan Duplex Speed Type
port1.0.18 Port_01 down 3 half 100 10/100/1000Base-T
port1.0.20 Port_02 up 11 auto auto 10/100/1000Base-T
Interface port1.0.1
Link is UP, administrative state is UP
Address is 0015.77cc.e243
index 1 mtu 9198
SNMP link-status traps: Enabled (Suppressed in 0 sec.)
Bandwidth 1g
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 0, bytes 0, multicast packets 0 broadcast packets 0
Interface port1.0.2
Link is UP, administrative state is UP
Address is 0015.77cc.e244
index 2 mtu 9198
SNMP link-status traps: Enabled (Suppressed in 0 sec.)