Chapter 8: Port Parameter Commands
166 Section II: Basic Operations
EGRESS-RATE-LIMIT
Syntax
egress-rate-limit
value
Parameters
value Specifies the maximum amount of traffic that can be
transmitted from the port. The value is kilobits per
second. The range is 64 to 1,000,000,000 kilobits per
second.
Mode
Port Interface mode
Description
Use this command to set a limit on the amount of traffic that can be
transmitted per second from the port.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 129
Example
This example sets the egress rate limit to 1,000,000 kilobits per second on
ports 15, 16 and 21:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15,port1.0.16,port1.0.21
awplus(config-if)# egress-rate-limit 1000000
To Next Page
Loading...
