Chapter 12: SNTP Client Commands
250 Section II: Basic Operations
NTP PEER
Syntax
ntp peer
ipaddress
Parameter
ipaddress Specifies an IP address of an SNTP or NTP server.
Mode
Global Configuration mode
Description
Use this command to activate the NTP client on the switch and to specify
the IP address of the SNTP or NTP server from which it is to obtain its
date and time. You can specify only one SNTP or NTP server. After you
enter this command, the switch automatically begins to query the network
for the defined server.
Confirmation Command
“SHOW NTP ASSOCIATIONS” on page 253
Example
This example defines the IP address of the SNTP server as
148.77.122.54:
awplus> enable
awplus# configure terminal
awplus(config)# ntp peer 148.77.122.54
To Next Page
Loading...
