AT-9000 Switch Command Line User’s Guide
Section II: Basic Operations 303
Displaying the Port Mirror
To display the port mirror, go to the User Exec mode or the Privileged
Exec mode and enter the SHOW MIRROR command:
awplus# show mirror
In this example of the information, the port mirror is enabled and the
ingress and egress packets on ports 1 and 3, as well as the egress traffic
on ports 11 to 13, are being copied to destination port 22.
Figure 64. SHOW MIRROR Command
The fields are described in Table 25 on page 308.
Port Mirroring:
Mirroring State ..................... Enabled
Mirror-To (Destination) Port ........ 22
Ingress (Rx) Mirror (Source) Ports .. 1,3
Egress (Tx) Mirror (Source) Ports ... 1,3,11-13
To Next Page
Loading...
