AT-9000 Switch Command Line User’s Guide
Section II: Basic Operations 321
IP IGMP LIMIT
Syntax
ip igmp limit
multicastgroups
Parameters
multicastgroups Specifies the maximum number of multicast
addresses the switch is allowed to learn. The range
is 0 to 255 multicast addresses; the default is 64
addresses.
Mode
Global Configuration mode
Description
Use this command to specify the maximum number of multicast addresses
the switch can learn. If your network has a large number of multicast
groups, you can use this parameter to limit the number of multicast groups
the switch will support.
Confirmation Command
“SHOW IP IGMP SNOOPING” on page 328
Example
This example sets the maximum number of multicast groups on the switch
to 25:
awplus> enable
awplus# configure terminal
awplus(config)# ip igmp limit 25
To Next Page
Loading...
