Chapter 27: File Transfer Commands
390 Section III: File System
COPY ZMODEM
Syntax
copy zmodem
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command together with a Zmodem utility to download boot
configuration files or CA certificates to the file system in the switch. This
command must be performed from a local management session. For
instructions on how to use this command, refer to “Downloading Files to
the Switch with Zmodem” on page 379.
Note
You may not use Zmodem to download new versions of the
management software to the switch. For that you must use TFTP.
Examples
awplus> enable
awplus# copy zmodem
The source file is not specified when downloading files with Zmodem.
After you enter the command, the management software displays this
message:
Waiting to receive.
Start the transfer by selecting the file with the Zmodem utility on your
terminal or computer.
To Next Page
Loading...
