Allied Telesis AT-9000/28 - Log Buffered; Table 37. Event Message Severity Levels

AT-9000 Switch Command Line User’s Guide
Section IV: Event Messages 401
LOG BUFFERED
Syntax
log buffered level level program program
Parameters
level Specifies the minimum severity level of the event
messages to be stored in the event log.
program Specifies the event messages of a particular
management software module. The modules are
listed in Table 39 on page 404. To specify more
than one module, separate the modules with
commas.
Mode
Global Configuration mode
Description
Use this command to specify the types of event messages to be stored in
the event log. You can specify the messages by severity level,
management software module, or both. The available severity levels are
listed in Table 37.
The management software modules are listed in Table 39 on page 404.
Confirmation Command
“SHOW LOG CONFIG” on page 406
Example
This example configures the event log to save only those event messages
that have the minimum severity level 4:
Table 37. Event Message Severity Levels
Severity Description
0 Emergency message
4 Warning message
6 Informational message
7 Debug message