Allied Telesis AT-9000/28 - Show Log; Table 38. SHOW LOG Command

AT-9000 Switch Command Line User’s Guide
Section IV: Event Messages 403
SHOW LOG
Syntax
show log
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command to display the messages in the event log. The event
messages are displayed from oldest to newest, one screen at a time. To
cancel the display, type ‘q’ for quit. You cannot filter the log for specific
types of messages. An example of the log is shown in Figure 74.
Figure 74. SHOW LOG Command
The columns in the log are described here:
<date> <time> <facility>.<severity> <program[<pid>]>: <message>
-------------------------------------------------------------------------
2010 Jan 15 14:39:04 user.information awplus stp: Set Configuration succeeded
2010 Jan 15 14:39:04 user.information awplus stp: Set Configuration succeeded
2010 Jan 15 14:39:04 user.information awplus stp: Disabled Spanning Tree
2010 Jan 15 14:39:04 user.information awplus stp: Active protocol changed to STP
Table 38. SHOW LOG Command
Parameter Description
Date/Time The date and time the message was
entered in the event log.
Facility This is always “user.”
Severity The severity of the message. The severity
levels are:
 Information: Useful information that
can be ignored during normal
operation.
 Error: Switch operation is severely
impaired.