AT-9000 Switch Command Line User’s Guide
Section I: Getting Started 41
Local Manager Account
You must log on to manage the switch. This requires a valid user name
and password. The switch comes with one local manager account. The
user name of the account is “manager” and the default password is
“friend.” The user name and password are case sensitive. This account
gives you access to all management modes and commands.
The default manager account is referred to as “local” because the switch
authenticates the user name and password itself. If more manager
accounts are needed, you can add up to eight more local manager
accounts. For instructions, refer to Chapter 70, “Local Manager Accounts”
on page 1093.
Another way to create more manager accounts is to transfer the task of
authenticating the accounts to a RADIUS or TACACS+ server on your
network. For instructions, refer to Chapter 82, “RADIUS and TACACS+
Clients” on page 1189.
The switch supports up to three manager sessions at one time.
To Next Page
Loading...
