Allied Telesis AT-9000/28 - Displaying Static Port Trunks

AT-9000 Switch Command Line User’s Guide
Section V: Port Trunks 433
Displaying Static Port Trunks
To display the member ports of static port trunks, use the SHOW STATIC-
CHANNEL-GROUP command in the User Exec mode or Privileged Exec
mode:
awplus# show static-channel-group
Here is an example of the information.
Figure 79. SHOW STATIC-CHANNEL-GROUP Command
To view the load distribution methods of static port trunks, display the
running configuration with “SHOW RUNNING-CONFIG” on page 129.
% Static Aggregator: sa1
% Member:
port1.0.5
port1.0.6
port1.0.7
% Static Aggregator: sa2
% Member:
port1.0.19
port1.0.20
port1.0.21
port1.0.22