Chapter 34: Link Aggregation Control Protocol (LACP)
450 Section V: Port Trunks
Deleting Aggregators
To delete an aggregator, remove all its ports with the NO CHANNEL-
GROUP command, in the Port Interface mode.
Caution
Do not delete an aggregator without first disconnecting the network
cables from its ports. Leaving the network cables connected may
result in a network loop, which can cause a broadcast storm.
These commands delete an aggregator consisting of ports 17, 22 and 23:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.17,port1.0.22,port1.0.23
awplus(config-if)# no channel-group
To Next Page
Loading...
