Chapter 35: LACP Commands
460 Section V: Port Trunks
SHOW ETHERCHANNEL
Syntax
show etherchannel
id_number
Parameters
id_number Specifies the ID number of the aggregator.
Mode
Privileged Exec mode
Description
Use this command to display the ports of specific aggregators on the
switch. Figure 83 illustrates the information.
Figure 83. SHOW ETHERCHANNEL Command
Example
This example displays the ports of the aggregator with the ID number 22:
awplus# show etherchannel 22
Aggregator #2 .... po2
Admin Key: 0xff01 - Oper Key: 0x0101
Link: Port1.0.2 sync
Link: Port1.0.3 sync
Link: Port1.0.4 sync
Link: Port1.0.5 sync
Link: Port1.0.6 sync
To Next Page
Loading...
