Chapter 38: STP Commands
502 Section VI: Spanning Tree Protocols
SPANNING-TREE MODE STP
Syntax
spanning-tree mode stp
Parameters
None.
Mode
Global Configuration mode
Description
Use this command to designate STP as the active spanning tree protocol
on the switch. You must select STP as the active spanning tree protocol
before you can enable it or configure its parameters.
Only one spanning tree protocol can be active on the switch at a time.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 129
Example
This example designates STP as the active spanning tree protocol on the
switch:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mode stp
To Next Page
Loading...
