AT-9000 Switch Command Line User’s Guide
Section VI: Spanning Tree Protocols 531
NO SPANNING-TREE PORTFAST
Syntax
no spanning-tree portfast
Parameters
None.
Mode
Port Interface mode
Description
Use this command to remove ports as edge ports on the switch. This
command is equivalent to “NO SPANNING-TREE” on page 527.
Example
This example removes port 21 as an edge port:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.21
awplus(config)# no spanning-tree portfast
To Next Page
Loading...
