AT-9000 Switch Command Line User’s Guide
Section VI: Spanning Tree Protocols 541
SPANNING-TREE LINK-TYPE
Syntax
spanning-tree link-type point-to-point|shared
Parameters
point-to-point Allows for rapid transition of a port to the forwarding
state during the convergence process of the spanning
tree domain.
shared Disables rapid transition of a port. You may want to set
link type to shared if a port is connected to a hub with
multiple switches connected to it.
Mode
Port Interface mode
Description
Use this command to designate point-to-point ports and shared ports.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 129
Examples
This example designates ports 11 to 23 as point-to-point ports:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11-port1.0.23
awplus(config-if)# spanning-tree link-type point-to-point
This example designates the links on ports 26 and 27 as shared links:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.26,port1.0.27
awplus(config-if)# spanning-tree link-type shared
To Next Page
Loading...
