Allied Telesis AT-9000/28 - Startup Messages

AT-9000 Switch Command Line User’s Guide
Section I: Getting Started 55
Startup Messages
The switch generates the following series of status messages whenever it
is powered on or reset. The messages can be view on the Console port
with a terminal or a computer with a terminal emulator program.
Figure 20. Startup Messages
awplus# umount: none busy - remounted read-only
umount: cannot remount rootfs read-only
umount: cannot umount /: Device or resource busy
The system is going down NOW !!
Sending SIGTERM to all processes.
Sending SIGKILL to all processes.
Requesting system reboot.
Restarting system.
/usr/bin:/bin:/usr/sbin:/sbin
Starting SNMP...
Starting MainTask...
Initializing System ............................ done!
Initializing Board ............................. done!
Initializing Serial Interface .................. done!
Initializing Timer Library ..................... done!
Initializing IPC ............................... done!
Initializing Event Log ......................... done!
Initializing Switch Models ..................... done!
Initializing File System ....................... done!
Initializing Database .......................... done!
Initializing Configuration ..................... done!
Initializing AW+ CLI ........................... done!
Initializing Drivers ........................... done!
Initializing Port .............................. done!
Initializing Trunk ............................. done!
Initializing Port Security ..................... done!
Initializing LACP .............................. done!
Initializing PORT VLAN ......................... done!
Initializing Port Mirroring .................... done!
Initializing Port Statistics ................... done!
Initializing Snmp Service ...................... done!
Initializing Web Service ....................... done!
Initializing Monitor ........................... done!
Initializing STP ............................... done!
Initializing SPANNING TREE ..................... done!
Initializing L2_MGMT ........................... done!
Initializing LLDP_RX ........................... done!
Initializing LLDP_TX ........................... done!
Initializing GARP .............................. done!
Initializing GARP Post Init Task ............... done!
Initializing IGMPSnoop ......................... done!