AT-9000 Switch Command Line User’s Guide
Section VI: Spanning Tree Protocols 551
SPANNING-TREE RSTP ENABLE
Syntax
spanning-tree rstp enable
Parameters
None.
Mode
Global Configuration mode
Description
Use this command to enable the Rapid Spanning Tree Protocol on the
switch. You cannot enable RSTP until you have activated it with
“SPANNING-TREE MODE RSTP” on page 544.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 129 or “SHOW SPANNING-TREE”
on page 533
Example
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree rstp enable
To Next Page
Loading...
