Allied Telesis AT-9000/28 - Disabling GVRP on the Switch

Chapter 43: GARP VLAN Registration Protocol
610 Section VII: Virtual LANs
Disabling GVRP on the Switch
To disable GVRP to stop the switch from learning any further dynamic
VLANs or GVRP ports, use the NO GVRP ENABLE command in the
Global Configuration mode. Here is the command.
awplus> enable
awplus# configure terminal
awplus(config)# no gvrp enable
For reference information, refer to “NO GVRP ENABLE” on page 622.