Allied Telesis AT-9000/28 - Gvrp Registration

Chapter 44: GARP VLAN Registration Protocol Commands
618 Section VII: Virtual LANs
GVRP REGISTRATION
Syntax
gvrp registration normal|none
Parameters
normal Enables GVRP on a port. This is the default setting.
none Disables GVRP on a port.
Mode
Port Interface mode
Description
Use this command to enable or disable GVRP on a port. A port where
GVRP is enabled transmits GVRP PDUs. A port where GVRP is disabled
does not send GVRP PDUs.
Examples
This example enables GVRP on ports 5 and 6:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5,port1.0.6
awplus(config-if)# gvrp registration normal
This example disables GVRP on port 20:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.20
awplus(config-if)# gvrp registration none