Allied Telesis AT-9000/28 - VLAN SET MACADDRESS (Global Configuration Mode)

AT-9000 Switch Command Line User’s Guide
Section VII: Virtual LANs 655
VLAN SET MACADDRESS (Global Configuration Mode)
Syntax
vlan set vid macaddress|destaddress mac-address
Parameters
vid Specifies the VID of the VLAN to be modified.
mac-address Specifies the MAC address to be added to the VLAN.
The MAC address must be entered in this format:
xx:xx:xx:xx:xx:xx
Note
The MACADDRESS and DESTADDRESS keywords are equivalent.
Mode
Global Configuration mode
Description
Use this command to add MAC addresses to MAC address-based VLANs.
You can add only one address at a time with this command. You cannot
use ranges or wildcards.
The specified VLAN must already exist. Refer to “VLAN MACADDRESS”
on page 653 for instructions on how to create MAC address-based
VLANs. To add MAC addresses to egress ports, use “VLAN SET
MACADDRESS (Port Interface Mode)” on page 657.
Confirmation Command
“SHOW VLAN MACADDRESS” on page 651
Examples
This example adds the MAC address 00:30:84:32:8A:5D to a MAC
address-based VLAN that has the VID 4:
awplus> enable
awplus# configure terminal
awplus(config)# vlan set 4 macaddress 00:30:84:32:8a:5d
This example adds the MAC address 00:30:84:32:76:1A to a MAC
address-based VLAN with the VID 12: