Allied Telesis AT-9000/28 - Show Port-Security Intrusion Interface

AT-9000 Switch Command Line User’s Guide
Section VIII: Port Security 711
SHOW PORT-SECURITY INTRUSION INTERFACE
Syntax
show port-security intrusion interface port
Parameter
port Specifies a port. You can specify more than one port
at a time.
Modes
Privileged Exec mode
Description
Use this command to display the number of packets the ports have had to
discard because the packets had unknown source MAC addresses. The
ports begin to discard packets after learning their maximum number of
source MAC addresses. This information is also available with “SHOW
PORT-SECURITY INTERFACE” on page 708.
Here is an example of the information.
Figure 120. SHOW PORT-SECURITY INTRUSION INTERFACE
Command
Example
This command displays the number of discarded packets on port 15:
awplus# show port-security intrusion interface port1.0.15
Port Security Intrusion List
--------------------------------------------------------
Interface: Port 1.0.4 - 122 intrusion(s) detected