Allied Telesis AT-9000/28 - Switchport Port-Security Maximum

Chapter 53: MAC Address-based Port Security Commands
714 Section VIII: Port Security
SWITCHPORT PORT-SECURITY MAXIMUM
Syntax
switchport port-security maximum value
Parameters
value Specifies the maximum number of dynamic MAC
addresses ports can learn. The range is 0 to 255
addresses. The default is 100 addresses.
Mode
Port Interface mode
Description
Use this command to specify the maximum number of dynamic MAC
addresses that ports can learn. Ports that learn their maximum numbers of
MAC addresses discard ingress packets with unknown MAC addresses.
Confirmation Command
“SHOW PORT-SECURITY INTERFACE” on page 708
Example
This example sets port 2 to learn up to 15 dynamic MAC addresses:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# switchport port-security maximum 15