AT-9000 Switch Command Line User’s Guide
Section VIII: Port Security 757
AUTH TIMEOUT SERVER-TIMEOUT
Syntax
auth timeout server-timeout
value
Parameters
server-timeout Sets the timer used by the switch to determine
authentication server timeout conditions. The range is
1 to 600 seconds. The default value is 30 seconds.
Mode
Port Interface mode
Description
Use this command to set the amount of time the switch waits for a
response from a RADIUS authentication server.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 777 or “SHOW DOT1X
INTERFACE” on page 782
Example
This example sets the timer on port 21 to 15 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.21
awplus(config-if)# auth timeout server-timeout 15
To Next Page
Loading...
