Allied Telesis AT-9000/28 - Show Running-Config Snmp

AT-9000 Switch Command Line User’s Guide
Section IX: Simple Network Management Protocols 811
SHOW RUNNING-CONFIG SNMP
Syntax
show running-config snmp
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command to display the SNMPv1 and v2c community strings and
the IP addresses of trap and inform receivers. An example is shown in
Figure 139.
Figure 138. SHOW RUNNING-CONFIG SNMP Command
Example
awplus# show running-config snmp
snmp-server
no snmp-server enable trap auth
snmp-server community sw12eng1 rw
snmp-server community sw12eng1limit rw
snmp-server community westplnm7 ro
snmp-server community site12pl4 ro
snmp-server host 149.198.74.143 traps version 2c sw12eng1
snmp-server host 149.198.74.154 traps version 2c sw12eng1
snmp-server host 149.198.121.17 traps version 2c sw12eng1limit
snmp-server host 149.198.121.198 traps version 2c sw12eng1limit