Chapter 57: SNMPv1 and SNMPv2c Commands
816 Section IX: Simple Network Management Protocols
SNMP-SERVER
Syntax
snmp-server
Parameters
None.
Mode
Global Configuration mode
Description
Use this command to activate SNMPv1, SNMPv2c and SNMPv3 on the
switch. The switch permits remote management from SNMP applications
when SNMP is enabled. The switch also sends SNMP messages to trap
and inform receivers.
Confirmation Command
“SHOW SNMP-SERVER” on page 812
Example
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server
To Next Page
Loading...
