AT-9000 Switch Command Line User’s Guide
Section IX: Simple Network Management Protocols 827
NO SNMP-SERVER
Syntax
no snmp-server
Parameters
None.
Mode
Global Configuration mode
Description
Use this command to disable SNMPv1, v2c and v3 on the switch. The
switch does not permit remote management from SNMP applications
when SNMP is disabled. It also does not send SNMP trap or inform
messages.
Confirmation Command
“SHOW SNMP-SERVER” on page 832.
Example
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server
To Next Page
Loading...
