Chapter 58: SNMPv3 Commands
832 Section IX: Simple Network Management Protocols
SHOW SNMP-SERVER
Syntax
show snmp-server
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command to display the current status of SNMP on the switch. An
example is shown in Figure 142. The first field displays whether SNMP is
enabled or disabled on the switch. You can remotely manage the switch
with SNMPv1 or v2c when the server is enabled. Remote management is
not possible when the server is disabled. To activate or deactivate SNMP,
refer to “SNMP-SERVER” on page 837 and “NO SNMP-SERVER” on
page 827, respectively.
Figure 142. SHOW SNMP-SERVER Command
Example
awplus# show snmp-server
SNMP Server ....... Enabled
IP Protocol ....... IPv4
SNMPv3 Engine ID (Configured) ........ Not set
SNMPv3 Engine ID (actual) ............ 0x80001f8880241d7f08386d438e
To Next Page
Loading...
