AT-9000 Switch Command Line User’s Guide
Section X: Network Management 857
Displaying the sFlow Agent
To view the IP addresses and UDP port settings of the collectors as
defined in the sFlow agent on the switch, use the SHOW SFLOW
database command in the Global Configuration mode. Here is the
command:
awplus(config)# show sflow database
Here is an example of what you’ll see.
Figure 143. SHOW SFLOW DATABASE Command
The fields are described in Table 82 on page 873.
To display just the port settings, use the SHOW SFLOW command, also in
the Global Configuration mode:
awplus(config)# show sflow
Here is a sample of the information.
Figure 144. SHOW SFLOW Command
The fields are described in Table 81 on page 870.
Number of Collectors: 1
Collector_address UDP_port
================== ========
149.122.78.12 6343
Number of Samplers/Pollers 4
Port Sample-rate Polling-interval
==== =========== ================
1.0.4 1000 60
1.0.12 1000 60
1.0.13 50000 2400
1.0.14 50000 2400
sFlow Status
============
Enabled
Port Sample-rate Polling-interval Collector-list
==== =========== ================ ==============
1.0.4 1000 60 149.122.78.12
1.0.12 1000 60 149.122.78.12
1.0.13 50000 2400 149.122.78.12
1.0.14 50000 2400 149.122.78.12
To Next Page
Loading...
