Allied Telesis AT-9000/28 - Show Sflow Database

Chapter 60: sFlow Agent Commands
872 Section X: Network Management
SHOW SFLOW DATABASE
Syntax
show sflow database
Parameters
None.
Modes
Global Configuration mode
Note
Unlike most other SHOW commands, which are stored in the User
Exec and Privileged Exec modes, this SHOW command is located in
the Global Configuration mode.
Description
Use this command to display the settings of the sFlow agent on the switch.
Here is an example of the information.
Figure 146. SHOW SFLOW DATABASE Command
Number of Collectors: 1
Collector_address UDP_port
================== ========
149.122.78.12 6343
Number of Samplers/Pollers 4
Port Sample-rate Polling-interval
==== =========== ================
1.0.4 1000 60
1.0.12 1000 60
1.0.13 50000 2400
1.0.14 50000 2400
sFlow Status
============
Enable