AT-9000 Switch Command Line User’s Guide
Section X: Network Management 885
Configuring Ports to Send Optional LLDP TLVs
This example illustrates how to configure the ports to send optional LLDP
TLVs along with the mandatory TLVs, to their neighbors. Refer to Table 84
for the list of optional LLDP TLVs.
This example configures ports 18 and 24 to send these optional TLVs,
along with the mandatory TLVs:
port-description
link-aggregation
mac-phy-config
Here are the commands to configure the ports to send the TLVs:
Table 86. Optional LLDP TLVs
TLV Designator Description
port-description Port description.
system-name System name
system-description System description
system-capabilities System capabilities
management-address Management IP address
port-vlan Port VLAN
port-and-protocol-vlan Port and Protocol VLANs
vlan-names Names of VLANs in which the port
is a member.
protocol-ids Protocol IDs
mac-phy-config Speed and duplex mode
power-management Power via MDI capabilities
link-aggregation Link aggregation status
max-frame-size The maximum supported frame
size of the port.
awplus> enable
Enter the Privileged Executive
mode from the User Executive
mode.
To Next Page
Loading...
