Allied Telesis AT-9000/28 - Disabling LLDP and LLDP-MED on the Switch

Chapter 61: LLDP and LLDP-MED
902 Section X: Network Management
Disabling LLDP and LLDP-MED on the Switch
To disable LLDP and LLDP-MED on the switch, use the NO LLDP RUN
command in the Global Configuration mode. The command has no
parameters. After the protocols are disabled, the switch neither sends
advertisements to nor collects information from its neighbors. The switch
retains its LLDP settings. Here is the command:
awplus> enable
awplus# configure terminal
awplus(config)# no lldp run