AT-9000 Switch Command Line User’s Guide
Section X: Network Management 907
Displaying Port TLVs
To view the TLVs of the individual ports on the switch, use the SHOW
LLDP LOCAL-INFO INTERFACE command in the User Exec mode or the
Privileged Exec mode. This command is useful whenever you want to
confirm the TLVs on the ports, such as after you’ve configured the ports or
if you believe that ports are not sending the correct information.
The command has this format:
show lldp local-info [interface
port
]
To view the TLVs on all the ports, enter this command:
awplus# show lldp local-info
This example displays the TLVs currently configured on port 2:
awplus# show lldp local-info interface port1.0.2
Refer to Figure 152 on page 953 and Figure 153 on page 954 for an
example of the information. The fields are defined in Table 94 on
page 956.
To Next Page
Loading...
