AT-9000 Switch Command Line User’s Guide
Section I: Getting Started 91
TERMINAL LENGTH
Syntax
terminal length
value
Parameters
value Specifies the maximum number of lines that the
SHOW commands display at one time on the screen.
The range is 0 to 512 lines. Use the value 0 if you do
not want the SHOW commands to pause.
Mode
Privileged Exec mode
Description
Use this command to specify the maximum number of lines the SHOW
commands display at one time on the screen during local management
session. To set this parameter for remote Telnet or SSH management
sessions, refer to “LENGTH” on page 87.
Examples
This example sets the maximum number of lines to 25:
awplus# terminal length 25
This example returns the number of lines to the default setting:
awplus# terminal no length
To Next Page
Loading...
