AT-9000 Switch Command Line User’s Guide
Section X: Network Management 917
LLDP MANAGEMENT-ADDRESS
Syntax
lldp management-address
ipaddress
Parameters
ipaddress Specifies an IP address.
Mode
Port Interface mode
Description
Use this command to replace the default management IP address TLV of
a port. The management IP address TLV is optional. A port must be
configured to transmit it.
A port can have one of two possible default values for the management IP
address TLV. The default value depends on whether a port is a member of
the same VLAN as the management IP address, if present. Here are the
possible default values for a port:
A port that belongs to the same VLAN as the management IP address
uses the address as its TLV default value.
A port that belongs to a VLAN that does not have a management IP
address, either because no address has been assigned to the switch
or it is assigned to a different VLAN, uses the MAC address of the
switch as its default value for this TLV.
A port that belongs to more than one VLAN uses the management IP
address as its default value if the address is assigned to its lowest
numbered VLAN. Otherwise, it uses the switch’s MAC address.
To return a port’s management IP address TLV to the default value, use
the NO form of this command.
Confirmation Command
“SHOW LLDP INTERFACE” on page 951
Examples
This example configures port 2 to transmit the IP address 149.122.54.2 as
its management IP address TLV:
awplus> enable
To Next Page
Loading...
