AT-9000 Switch Command Line User’s Guide
Section X: Network Management 919
LLDP MED-NOTIFICATIONS
Syntax
lldp med-notifications
Parameters
None.
Mode
Port Interface mode
Description
Use this command to configure the switch to send LLDP-MED topology
change notifications when devices are connected to or disconnected from
the specified ports. To prevent the switch from transmitting topology
change notifications, refer to “NO LLDP NOTIFICATIONS” on page 943.
Confirmation Command
“SHOW LLDP INTERFACE” on page 951
Example
This example configures the switch to send LLDP-MED topology change
notifications whenever devices are connected to or removed from ports 11
and 17:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11,port1.0.17
awplus(config-if)# lldp med-notifications
To Next Page
Loading...
