AT-9000 Switch Command Line User’s Guide
Section X: Network Management 923
LLDP NOTIFICATIONS
Syntax
lldp notifications
Parameters
None.
Mode
Port Interface mode
Description
Use this command to configure ports to send LLDP SNMP notifications
(traps). To prevent ports from transmitting LLDP SNMP notifications, refer
to “NO LLDP NOTIFICATIONS” on page 943.
Confirmation Command
“SHOW LLDP INTERFACE” on page 951
Example
This example configures ports 2 and 3 to transmit SNMP notifications:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.2,port1.0.3
awplus(config-if)# lldp notifications
To Next Page
Loading...
