Chapter 62: LLDP and LLDP-MED Commands
932 Section X: Network Management
LLDP TX-DELAY
Syntax
lldp tx-delay
value
Parameters
value Specifies the transmission delay timer in seconds.
The range is 1 to 8192 seconds.
Mode
Global Configuration mode
Description
Use this command to set the value of the transmission delay timer. This is
the minimum time interval between transmissions of LLDP advertisements
due to a change in LLDP local information. The transmission delay timer
cannot be greater than a quarter of the transmit interface, set with “LLDP
TIMER” on page 927. To view the current value, refer to “SHOW LLDP” on
page 949.
Confirmation Command
“SHOW LLDP” on page 949
Example
This example sets the transmission delay timer to 120 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# lldp tx-delay 120
To Next Page
Loading...
